Peridata Repair and Support Centre, for free knowledge and advice.


Model PD-2040 (
Tandberg SLR7) Specifications

Navigation: Tape Drives > SLR7 Features > Specifications >
 

   
General Specifications Dimensions
Format and Compatibility Power Requirements
Media Retention Environmental Specifications
Reliability & Error Correction SLR 7 Configuration
Tape Motion Data Solutions

 

General Specifications

Drive

SLR7

Capacity (formatted)

Native/Compressed*

20GB/40GB*

Buffer Size

 

8MB

Data Transfer Rate

Native Sustained

3.0MB

 

Compressed Sustained*

6.0MB/sec

 

Compressed Sustained*

21.6GB/hr

 

Burst

40MB/sec Notes 1

File Access Time

Typical

<89 sec

Media Load Time

Typical

<30 sec

System Interface

 

 SCSI-3 Multimode Wide Ultra (SE)Ultra2 (LVD) Note1

Drive Warranty

  3-years Factory

Format, Compatibility and Media

Recording Format

 

SLR7

Encoding/Decoding

 

VR Note2 RLL

Number of Tracks

 

72 data tracks

Written Bit density

kfci

152.4

Backward Write

 

SLR7

Backward Read

 

SLR7, SLR5

Media

Media Data Retention

Archival Life

>20 years

Data Cartridges

 

PD-8240
    SLRtape7

Reliability and Error Correction

Hard Read Error Rate

  <10 Notes 1

Read Solomon ECC

  Level 10,  8 interleaves

Mean Time Between Failures (MTBF)

  300,000 hours (20% duty cycle)

Mean Time To Repair
(MTTR)

  <30 minutes

Tape Motion

Tape Speed

Read/Write

105.0 ins/sec

 

Wind/Rewind

105.0 ins/sec

Start Time

Typical at 105 ins/sec

380ms

Stop Time

Typical at 105 ins/sec

250ms

Dimensions

 

Internal Drive External Drive

 

 

 

Form Factor

Internal 5.25-inch half height (HH)

Height

1.732 ins (44mm) 4.44 ins (113mm)

Width

5.905 ins (150mm) 7.610 ins (193mm)

Depth

8.583 ins (218mm) 12.262 ins (311mm)

Weight

Internal External

 

 

2.4 lb (1.1kg) 9.02 lb (4.1kg)

Power Requirements Typical

Internal Drive

Power Consumption

 

 

 

+5V dc excluding
bus terminator

1.2A motor not running

+5V dc excluding
bus terminator

1.5A motor running

+12V dc Standby

100mA

+12V dc Running

1.3A
 

Standby

N/A
 

Running

N/A

Voltage Variations

 

+5V dc ±5%  125mV maximum ripple
  +12V dc ±10% 200mV maximum ptp ripple

Power Requirements

External Drive

Power Consumption

  100 to 240V ac / 0.6 to 0.3A, 50 to 60Hz

Environmental Specifications

Temperature

Operating

5°C to 40°C (41°F to 104°F)

 

Storage

-30°C to 60°C (-22°F to 140°F)

Relative Humidity

Operating

20% to 80%

 

Transport

5% to 95%

Maximum Wet Bulb Temperature

 

26°C (79°F)

Altitude

Operating

13,000 feet (4,000 meters)

 

Transport

40,000 feet (12,200 meters)

Regulatory Agency Approvals

 

 

UL 1950, CAN/CSA-C22.2 No. 950, EN 60950, IEC60950, AS/NZS 3548, EN 55022 (CISPR22);
FCC part 15 Class B, ICES-003, VCCI, EN55024,
CE, C-Tick
Note *  Assuming 2:1 data compression.
Note 1 Burst transfer rate is limited to 40MB/S (20 megatransfer)
Note 2 Internal drive ability to meet specifications is dependant on installation configuration.

Tandberg SLR7 Configurations

Item

Drive Kit Complete Solution

Drive

Internal External Internal External

CD Software Suite (with instruction manual on CD)

    yes yes

Internal SCSI Wide Cable with Termination (removable)

yes   yes  

External SCSI Cable

  yes   yes

External SCSI Terminator (LVD/SE)

  yes   yes

Data Cartridge

yes yes yes yes

Cleaning Cartridge

yes yes yes yes

Power Cable

  yes   yes

 

Tandberg Data Solutions
Drive

SLR7

Work Group Edition: ARCserve®2000 for
Windows 2000, NT and NetWare

Other operating system support:
Sun Solaris, AIX, SCO-Unix, UnixWare, UNIX, HP-UX, Linux
OS
Macintosh, Windows 98, NT Workstation
Note Complete solution available
Note OS Supported in operating system
Note Support available through other software
SLR7 Features 

 

 

 Tape Drives | Products | Accessories | Service  and Support

 

Peridata Communications Pty. Ltd.

3 Bertram Street, Mortlake. NSW Australia 2137

ABN 64 003 065 049

Phone:

+61 2 9736-3966

Fax:

+61 2 9736-3596

E-mail:

sales@peridata.com.au

 

information@peridata.com.au

Copyright © 1986 - 2007

 repair.centre@peridata.com.au